Instructions – Bugeyeguy
“Never have I met a vendor so sharing in a passion to get it right, to enjoy the spirit of the Sprite, and infect others to join the tribe!”
- John P., Kansas

Order online for the fastest service! Use the search window to find the parts you need!

For tech support and phone orders:
(203)-208-0980 or David@bugeyeguy.com

Instructions

Solid State Fuel Pump & Nutsert Installation

Solid State Fuel Pump & Nutsert Installation

Our preferred mounting location for the solid state fuel pump is on the passenger side of the rear bulkhead.   To mount the pump, two rivet nuts must be installed in the bulkhead. 1.) Using the pump as a template, mark both mount holes and drill them open with a 3/8" bit. 2.) Setup the nutsert tool and nut as pictured below. First, insert the allen bolt through the nutsert tool. Then thread the insert nut onto the allen bolt with the flange side closest to the tool. Be sure the insert tool is fully threaded together, and that the...

Read more →


Front flip nose kit installation

1.) Jack up the front of the car and remove the front wheels. Remove the grill from the hood. Remove the hood from the car as well the rear hinges, hood latch, support struts, and locator pins. 2.) Remove the bumper and bumper brackets. 3.) Using a cut off wheel or grinder, cut back the protrusion that seats the rearward bolt point of the bumper brackets. 4.) Using a 3/8" drill bit, drill out the hole of the forward bracket mount.  5.) Find a small item about 1/8" thick to tape over the location holes to use as a spacer....

Read more →